Use the I/0 Simulator screen and the addresses shown to simulate the program. When the operator puts a part on an empty carrier, he or she pushes PB2, turning output 0:4/6 on. If the part fails, the inspectors push PB 1 as they remove the part from the system, which turns output 0:4/4 off ► Rework is added back into the system at station #6. ► They tum off as empty carriers move through. ► Pilot lights connected to output module 0:4 tum on as carriers with parts move through the machine.

The sequence of operation is as follows: ► Proximity switch # 1 senses a carrier, while proximity switch #2 senses a part on the earner. Count PB_ 1:1/0 Count-Down-Counter_ C5:0 Output PL_ 0:2/0 Input Lt pr: �-r ladder logic program Coun Output I 2 Preset Accumulated CS:0 [DN L2 COUNT-DOWN COUNTER CS:0 Counter 4 Output PL ( 105 NAME _ _ DATE_ 12-10 Implement the shift register program used to keep track of carriers flowing through the 16-station program shown. Use the I/O Simulator screen and the following addresses to simulate the program. Use the I/O Simulator screen and the following addresses to simulate the program: PBl (Start)_ 1:1/0 PB2 (Stop)_ 1:1/1 PSl _ 1:1/2 LSl _ 1:1/3 SSl _ 1:1/4 PLl _ 0:2/0 SOL 1 _ 0:2/1 SOL 2 _ 0:2/2 SOL 3 _ 0:2/3 PL2 _ 0:2/4 47 DATE_ _ AME _ _ _ Use the Batch Simulator screen and the following addresses in developing the program: Start PB_ 1:1/0 Stop PB_ 1:1/1 Low-Level Sensor_ 1:1/3 High-Level Sensor_ 1:1/4 Ingredient A Flowmeter_ 1:1/5 Input Pump Pl _ 0:2/1 Input Pump P2 _ 0:2/2 Discharge Pump P3_ 0:2/3 Mixer Motor_ 0:2/0 Heater_ 0:2/4 Idle PL_ 0:2/6 Run PL_ 0:2/5 Full PL_ 0:2/7 Internal Relay_ B3:0/0 CTU_ CS:1 RTO_ T4:1 RTO T4:2 8-39 Implement the count-down counter program shown with the preset value set to 2 and the initial accumulated value set to 4.

Use the I/O Simulator screen and the following addresses to simulate the program: Stop (NO Button)_ 1:1/0 Run (NO Button)_ 1:1/1 Jog (NO Button)_ 1:1/2 M_ O:2/0 L2 L1 STOP AUN OL _L JOG M 6-34 Write a documented PLC program that will execute the hardwired control circuit shown. NAME _ DATE _ l2 L1 STOP Start _L 0-, STOP _clart -1 2M /Pl2' 6-33 Write a documented PLC program that will implement the jogging control relay schematic shown.

Logixpro simulator pdf